What are Rose Borers?
There are actually several wasps and bees that nest in the center pith of cut rose bush canes. The cane boring insects bore a hole down into the center pith of the rose canes in order to create nests for their young. The two most common cane borers are actually small wasps. They are very active at seeking out the cut ends of rose canes to bore down into from early spring all the way through early fall. The most common cane borers are predators of aphids and use them to feed their young, thus they are a mix of good guy and bad guy in our rose beds. Rose borer damage can be easily spotted by the hole they leave in the center pith of the cut rose canes. Girdling may also be seen along the stem. The depth of the boring itself may only be a few inches (8 cm.) deep, while the most damaging and life threatening to the rose bush can go all the way to the main crown of the plant.
Controlling Rose Cane Borers
A good way to help prevent them from boring into the ends of rose canes is to seal the cut ends immediately after pruning or deadheading (the removal of old spent blooms). The use of Elmer’s multi-purpose glue or the white tacky glue available at craft stores is great to use for sealing the cut ends of the canes. Once dry, the glue creates a good hard cap over the ends that make it difficult for the cane borers to do what they desire to do. Thus, they will look for an easier target. Be careful what you use to seal the canes, as some paint, fingernail polish, and wood glues contain chemicals that will cause slight to severe die back of the cane that it is applied to, making the need for pruning again and losing more of the rose cane. Also, the “school glue” should not be used for this sealing purpose as it tends to wash off with watering or rainfall, leaving the end of the canes unprotected. Once the cane borer damage is spotted, the cane should be pruned down far enough to get below the borers hole and nest. This pruning can be significant due to some of the borers liking to bore as deeply as they can. Once the cane is pruned below the boring and nest, seal the end of the cane with the white glue and make sure the entire cut end of the cane is well covered. Do not apply the glue so abundantly that it runs down the sides of the cane; just make a nice cap on the canes. Should the glue run down, however, wipe this excess off with a damp cloth or towelette. It is good to have some damp paper towels with you when you go to the rose bed or garden to perform this task.
Rose Cane Borer Treatment
Should the borer have made it all the way to the crown of the rose bush, use a needle to probe the hole lightly that extends into the rose crown. In this way, you may be able to remove the nest and sometimes the culprit borer. Do not probe around too much so as to cause more harm though. Once done with the probing inspection, seal the bored hole with the white glue and sprinkle lightly with some surrounding garden soil. If the borer and/or nest have been removed, the bush should be able to overcome the intrusion. It is extremely important to prune the bored cane well enough to remove the nest; otherwise, a new crop of cane borers will mature to bring about more damage to the rose bushes. Good rose bed inspection and sealing of pruned rose canes are the best preventatives for cane borer damage. While systemic rose bush insecticidal additives may be somewhat successful, the damage they can do to the balance of the beneficial organisms in the soil of the rose bushes may not be worth it.
